PLANET WGSD-1022 - Manual (Page 324)

5.27.12 switchport general pvid
The switchport general pvid interface configuration command configures the PVID when the interface
is in general mode. To configure the default value, use the no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
ƒ vlan-id — PVID (Port VLAN ID). The vlan-id may belong to a non-existent VLAN.
Default Configuration
VLAN ID=1
Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to configure the PVID for e8, when the interface is in general mode.
Console (config)# interface ethernet e8
Console (config-if)# switchport general pvid 234
5.27.13 switchport general ingress-filtering disable
The switchport general ingress-filtering disable interface configuration command disables port
ingress filtering.
To enable ingress filtering on a port, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode