PLANET WGSD-1022 - Manual (Page 178)

5.7.15 show interfaces status
The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | out-of-band-eth
oob-interface]
ƒ Interface — A valid Ethernet port.
ƒ port-channel-number — A valid port-channel trunk index.
ƒ oob-interface — Out of band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status for all configured interfaces.
Console# show interfaces status
Port Type Duplex Speed Neg Flow Link Back Mdix
Control State Pressure Mode
----- -------- ------------ ----------- ------------ ----------- ---------- ------------ -----------
e1 100 Full 100 Auto On Up Enable On
e1 100 Full 100 Off Off Down Disable Off
e2 100 Full 100 Off Off Up Disable On
Ch Type Duplex Speed Neg Flow Back Link
Control Pressure State
------- -------- ----------- ----------- --------- ------------- -------------- ---------
1 1000 Full 1000 Off Off Disable Up
The displayed port status information includes the following:
ƒ Port—The port number.
ƒ Description—If the port has a description, the description is displayed.
ƒ Port Type—The port designated IEEE shorthand identifier. For example, 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
ƒ Duplex—Displays the port Duplex status.