PLANET WGSD-1022 - Manual (Page 341)

no dot1x timeout tx-period
ƒ seconds — Time in seconds that the switch should wait for a response to an EAP -request/identity
frame from the client before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet)
Examples
The following command sets the number of seconds that the switch waits for a response to an EAP -
request/identity frame, to 3600 seconds.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout tx-period 3600
5.29.9 dot1x max-req
The dot1x max-req interface configuration command sets the maximum number of times that the switch
sends an Extensible Authentication Protocol (EAP) - request/identity frame (assuming that no response
is received) to the client, before restarting the authentication process. Use the no form of this command
to return to the default setting.
Syntax
dot1x max-req count
no dot1x max-req
ƒ count — Number of times that the switch sends an EAP - request/identity frame before restarting
the authentication process. (Range: 1 - 10)
Default Configuartion
2
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example sets the number of times that the switch sends an EAP - request/identity frame, to