PLANET WGSD-1022 - Manual (Page 46)

4.4.2 Port Config
In this port setting screen (refer to figure 4-12), the parameters managing ports that are part of a VLAN
will be provided, and you can set the default VLAN ID (PVID). All untagged packets arriving to the device
are tagged by the ports PVID.
Figure 4-12 VLAN Port Setting screen
The page contains the following fields:
• Port#
Displays the port number included in the VLAN
• Mode
Indicates the port mode. Possible values are:
• General - The port belongs to VLANs, and each VLAN is
user-defined as tagged or untagged (full 802.1Q mode).
• Access - The port belongs to a single untagged VLAN. When a
port is in Access mode, the packet types which are accepted on the
port (packet type) cannot be designated. It is also not possible to
enable/ disable ingress filtering on an access port.
• Trunk - The port belongs to VLANs in which all ports are tagged
(except for an optional single native VLAN).
• Acceptable Frame Type Packet type accepted on the port. Possible values are:
• Admit Tag Only - indicates that only tagged packets are accepted
on the port.
• Admit All - indicates that both tagged and untagged packets are
accepted on the port.
• PVID
Assigns a VLAN ID to untagged packets. The possible values are 2 to
4094. VLAN 4095 is defined as per standard and industry practice as
the discard VLAN. Packets classified to the Discard VLAN are dropped