PLANET WGSD-1022 - Manual (Page 70)

4.7.4 Rate Limit
The Bandwidth screen (refer to figure 4-30) allows network managers to define the bandwidth settings for
a specified egress interface. Modifying queue scheduling affects the queue settings globally. The
Bandwidth screen is not used with the Service mode, as bandwidth settings are based on services.
Figure 4-30 Rate limit screen
Queue shaping can be based per queue and/or per interface. Shaping is determined by the lower
specified value. The queue shaping type is selected in the Bandwidth screen, include interface, port, LAG,
Rate Limit, Ingress Rate Limit Status, Rate Limit….
The page contains the following fields:
• Port#
Indicates the interface for which the queue shaping information is
displayed. The possible field values are:
• Port, indicates the port for which the bandwidth settings are
displayed.
•
LAG, indicates the LAG for which the bandwidth settings are
displayed.
• Ingress Rate Limit
Status
which indicates if rate limiting is defined on the interface
• Rate Limit
(62-1000000 Kbps)
Defines the amount of bandwidth assigned to the interface.
The possible field values are 62-1000000 Kbps.
• Egress Shaping
Indicates if rate limiting is enabled on the interface.