PLANET WGSD-1022 - Manual (Page 80)

• Rst, indicates the connection is dropped.
• Syn, indicates request to start a session.
• Fin, indicates request to close a session.
• Source Port
Defines the TCP/UDP source port to which the ACE is matched. This
field is active only if 800/6-TCP or 800/17-UDP is selected in the
Select from List drop-down menu.
The possible field range is 0 - 65535
• Destination Port
Defines the TCP/UDP destination port. This field is active only if
800/6-TCP or 800/17-UDP is selected in the Select from List
drop-down menu.
The possible field range is 0 - 65535
• Source IP Address Matches the source port IP address to which packets are addressed
to the ACE
• Wildcard Mask
Defines the source IP address wildcard mask. Wildcard masks
specify which bits are used and which bits are ignored.
A wild card mask of 255.255.255.255 indicates that no bit is
important.
A wildcard of 0.0.0.0 indicates that all the bits are important.
For example, if the source IP address 149.36.184.198 and the
wildcard mask is 255.36.184.00, the first eight bits of the IP address
are ignored, while the last eight bits are used.
• Destination IP
Address
Matches the destination port IP address to which packets are
addressed to the ACE
• Wildcard Mask
Defines the destination IP address wildcard mask
• Match DSCP
Matches the packet DSCP value to the ACE. Either the DSCP value
or the IP Precedence value is used to match packets to ACLs.
The possible field range is 0-63
• Match IP
Precedence
Matches the packet IP Precedence value to the ACE. Either the
DSCP value or the IP Precedence value is used to match packets to
ACLs.
The possible field range is 0-7
Use the Add to Table button when you add the configured IP Based ACLs to the IP Based ACL Table at
the bottom of the screen.