PLANET WGSD-1022 - Manual (Page 206)

Syntax
lacp port-priority value
no lacp port-priority
ƒ value — Port priority value. (Range: 1 - 65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the priority value for port e8 to 247.
Console (config)# interface ethernet e8
Console (config-if)# lacp port-priority 247
5.11.3 lacp timeout
The lacp timeout interface configuration command assigns an administrative LACP timeout. To reset the
default administrative LACP timeout use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
ƒ long — Specifies a long timeout value.
ƒ Short — Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.