PLANET WGSD-1022 - Manual (Page 233)

5.17.7 qos map dscp-queue
The qos map dscp-queue global configuration command modifies the DSCP to queue map. To return to
the default map, use the no form of this command.
Syntax
qos map dscp-queue dscp-list to queue-id
no qos map dscp-queue
• dscp-list—Specify up to 8 DSCP values, separate each DSCP with a space. (Range: 0 - 63)
• queue-id—Enter the queue number to which the DSCP value corresponds.
QoS Commands
qos trust (Global)
Copyright © 2004 Marvell CONFIDENTIAL Doc. No. MV-S200005-00 Rev. C
January 19, 2004, Preliminary
Document Classification: Proprietary Information Page 147
Default Configuration
The following table describes the default map.
Command Mode
Global Configuration mode
User Guidelines
Queue settings for 3, 11, 19, ... cannot be modified.
Example
The following example maps DSCP values 33, 40 and 41 to queue 1.
Console (config)# qos map dscp-queue 33 40 41 to 1
5.17.8 qos trust (Global)
The qos trust global configuration command can be used in basic mode to configure the system to
"trust" state.
To return to the default state, use the no form of this command.
Syntax
qos trust {cos | dscp | tcp-udp-port}}
no qos trust