PLANET WGSD-1022 - Manual (Page 177)

Command Modes
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration for all configured interfaces:
console# show interfaces configuration
Flow Admin Back Mdix
Port Type Duplex Speed Neg control State Pressure Mode
-------- ------------ ------ ----- -------- ------- ----- -------- ----
e1 100M-Copper Full 100 Enabled Off Up Disabled Auto
e2 100M-Copper Full 100 Enabled Off Up Disabled Auto
e3 100M-Copper Full 100 Enabled Off Up Disabled Auto
e4 100M-Copper Full 100 Enabled Off Up Disabled Auto
e5 100M-Copper Full 100 Enabled Off Up Disabled Auto
e6 100M-Copper Full 100 Enabled Off Up Disabled Auto
e7 100M-Copper Full 100 Enabled Off Up Disabled Auto
e8 100M-Copper Full 100 Enabled Off Up Disabled Auto
g1 1G-Combo-C Full 1000 Enabled Off Up Disabled Auto
g2 1G-Combo-C Full 1000 Enabled Off Up Disabled Auto
Flow Admin
Ch Type Speed Neg control State
-------- ------- ----- -------- ------- -----
ch1 -- -- Enabled Off Up
ch2 -- -- Enabled Off Up
ch3 -- -- Enabled Off Up
ch4 -- -- Enabled Off Up
ch5 -- -- Enabled Off Up
ch6 -- -- Enabled Off Up
ch7 -- -- Enabled Off Up
ch8 -- -- Enabled Off Up
The displayed port configuration information includes the following:
ƒ Port—The port number.
ƒ Port Type—The port designated IEEE shorthand identifier. For example 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
ƒ Duplex—Displays the port Duplex status.
ƒ Speed—Refers to the port speed.
ƒ Neg—Describes the Auto-negotiation status.
ƒ Flow Control—Displays the Flow Control status.
ƒ Back Pressure—Displays the Back Pressure status.
ƒ MDIX Mode—Displays the Auto-crossover status.
ƒ Admin State—Displays whether the port is enabled or disabled.