PLANET WGSD-1022 - Manual (Page 239)

Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, multiple radius-server host commands can be used.
If no host-specific timeout, retransmit, deadtime or key values are specified, the global values apply to
each host.
To define a radius server on the out-of-band port, use the out-of-band IP address
format —oob/ip-address.
The address type of the source parameter must be the same as the ip-address parameter.
Example
The following example specifies a RADIUS server host with the following characteristics:
ƒ Server host IP address — 192.168.10.1
ƒ Authentication port number — 20
ƒ Timeout period — 20 seconds
Console (config)# radius-server host 192.168.10.1 auth-port 20 timeout 20
5.18.2 radius-server key
The radius-server key global configuration command sets the authentication and encryption key for all
RADIUS communications between the router and the RADIUS daemon. To reset to the default, use the
no form of this command.
Syntax
radius-server key [key-string]
no radius-server key
ƒ key-string — Specifies the authentication and encryption key for all RADIUS communications
between the router and the RADIUS server. This key must match the encryption used on the
RADIUS daemon. The key can be up to 128 characters long.
Default Configuration
The default is an empty string.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.