Parker Products COMPAX-M /-S (L) - Manual (Page 126)

Operating Instructions COMPAX-M / -S
Output of variable voltage
126
Optimization
process:
Note
♦ The arrows behind the parameters show the preferred
direction for the parameter optimization.
↓ Reduce parameter
↑ Increase parameter
↓↑ Both directions could lead to a better setting.
The optmizing direction shown usually leads
to a good control result in our experience:
however, this cannot apply to every
application case!
Sensor
?
Select structure/parameter
variant 1
P59=4
(Optimise P24 if necessary)
Select structure/parameter
variant 2
P59=3
(Optimise P24 if necessary)
Set motor
Configure drive type:
Parameters P81 ... P92
Motor with
resolver
Motor with
SinCos 
Increase control dynamic
Increase P23
Travel slowly over the positioning range
⇒ stable, quiet travelling
⇒ unstable, unquiet travelling
(no longer corresponds to to the requirements)
Reset P23 to the last setting
User-defined settings
Modify P56 ↓↑ (D section rpm controller)
Increase P23
Travel slowly over the positioning range
⇒ stable, quiet travelling
⇒ unstable, unquiet travelling
(no longer corresponds to to the requirements)
Reset P23 & P56 to the last setting
Implement the same process for P57 ↓ (lag D
sectionl), P58 ↓ (lag rpm filter) and P151 ↓↑
(monitor speed)!
Optimizing the movement cycle
Optimise pre-control parameters P25 ↓↑ (rpm
pre-control), P26 ↓ (acceleration pre-control), P69
↓ (current pre-control) and P70 ↓ (return pre-
control).
Check current restriction:
During acceleration/braking, the current limit
should not be reached or only briefly.
The optimizing display (P233/234=13 and 14)
shows the time in which the controller is operating
at the current limit.
Use the pre-control parameters or increase
ACCEL to reduce the "time at current limit".
Further
optimization?
Further
optimization?
User-defined settings with variant 3
(P59= 8)
Modify P56 ↓↑ (D section rpm controller)
Increase P23
Travel slowly over the positioning range
⇒ stable, quiet travelling
⇒ unstable, unquiet travelling
(no longer corresponds to to the requirements)
Reset P23 & P56 to the last setting
Implement the same process for P57 ↓ (lag D
section), P58 ↓ and (lag rpm filter)!
yes
yes
no
no
Evaluate results.
Set best result.