Parker Products COMPAX-M /-S (L) - Manual (Page 53)

Interfaces
53
Unit
hardware
Connector
assignment / cable
Technical data
Configuration
Positioning and control functions
Optimization
functions
Interfaces
Accessories /
options
Status
Parameter
Error list
7.9.2 Digital inputs and outputs for COMPAX 1000SL
COMPAX 1000SL physically has 8 digital inputs and 8 digital outputs which are
assigned to connector X19.
COMPAX internally has 16 logic inputs and 16 logic outputs, some of which have
functions assigned to them. This means that not all logic inputs and outputs can be
interrogated or output via physical inputs and outputs. In order to enable flexible
assignment, a matrix was created for input and output assignment respectively
which makes it possible to assign the logic inputs and outputs to any of the
physical inputs and outputs. The matrices for allocation are realized via parameters
P156 to P160 (see Page 140). The assignment described below applies to
COMPAX 1000SL (standard unit) with default settings for parameters P156 to
P160.
X19
Pin Assign-
ment Meaning for COMPAX 1000SL standard unit and default
settings for parameters P156 to P160
1. GND
2. Input
SHIFT ="0" ="1"
3. Input Manual+ Find machine zero
4. Input Hand– Approach real zero
5. Input Quit Teach real zero
6. Input START -
7. Input Stop (interrupts
data record) Break (breaks off
data record)
8. Input Freely assignable in the standard unit. (I12)
9. Input Freely assignable in the standard unit. (I16)
10. reserved
11. Emergen
cy stop
Emergency stop input (emergency stop is triggered
by voltage < 15V DC)
12. Enable COMPAX 1000SL is enabled by 24V DC at X19/12
13. Override Input voltage 0 - +5V.
14. GND
15. Output
="1":No fault
="0":errors E1 ... E58; the drive does not accept
any positioning commands.
After "Power on" O1 remains at "0" until after the
self test.
16. Output ="1":No warning
="0":Error
≥ E58
17. Output Machine zero has been approached
18. Output Ready for start
19. Output Programmed set point reached
20. Output Idle after stop
21. Output Freely assignable in the standard unit. (O7)
22. Output Freely assignable in the standard unit. (O8)
23. 24VDC Load < 50mA
24. Ready P Ready contact for building a safety chain
25 pin Sub-D
socket strip
screw
connection
UNC4-40
14
25
1
13
25. Ready S Ready contact for building a safety chain
Note the assignment for unit variants and for special functions.
Assignment X19
for COMPAX
1000SL