Parker Products COMPAX-M /-S (L) - Manual (Page 91)

Configuration via PC using "ServoManager"
Installing ServoManager
91
Unit
hardware
Connector
assignment / cable
Technical data
Configuration
Positioning and control functions
Optimization
functions
Interfaces
Accessories /
options
Status
Parameter
Error list
8.3 Configuration via PC using "ServoManager"
There is a separate manual describing how to work with ServoManager.
8.3.1 Installing ServoManager
Before installation, deactivate the following programs:
♦ any virus detection software.
♦ the Miro Pinboard in Miro graphic cards.
Information concerning these programs.
Following installation, the virus software can be reactivated.
Problems may also occur during program execution with Miro Pinboard.
Start the "Setup.exe" program on disk 1. The installation is a menu-guided process.
Following the installation, a Windows program group will appear containing the
ServoManager and the terminal.
8.3.2 Configuring COMPAX
♦ Create connection to COMPAX: cable SSK1 (see Page 59).
♦ Call up ServoManager.
♦ Create a new project (Menu: Project: New).
♦ Using the menu "Axis: Insert: From controller" to set up an axis which contains all
COMPAX settings (all parameters: including system parameters and data
records, curves are also available for COMPAX XX70).
♦ Use the menu "Servo-Tools: to switch to ParameterEditor.
♦ Call up menu "Configuration: Guided configuration".
All configuration parameters are queried one after another.
8.3.3 Individual configuration of synchronous motors
In addition to the motors contained in ServoManager / ParameterEditor, you can
configure almost all synchronous motors. The conditions required for the motors
and resolvers are listed in the start-up manual under "Technical data".
To modify motor parameters, the motor must be switched off (use OUTPUT O0=1
or press the "-" button on the front plate while switching on COMPAX).
You will find the data required for this on the HAUSER motor type plate.
Preparation
Installation