Allied Telesis AT-S63 - Manual (Page 111)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Features 111
DISABLE SNMP AUTHENTICATETRAP
Syntax
disable snmp authenticatetrap|authenticate_trap
Parameters
None.
Description
This command stops the switch from sending authentication failure traps
to trap receivers. However, the switch will continue to send other system
traps, such as alarm traps. The default setting for sending authentication
failure traps is disabled.
The AUTHENTICATETRAP and AUTHENTICATE_TRAP keywords are
equivalent.
To activate the authentication failure trap, refer to “ENABLE SNMP
AUTHENTICATETRAP” on page 114.
Example
The following command instructs the switch not to send authentication
failure traps to SNMP trap receivers:
disable snmp authenticatetrap