Set switch mirror – Allied Telesis AT-S63 User Manual
Page 194
Advertising
Chapter 12: Port Mirroring Commands
194
Section I: Basic Operations
SET SWITCH MIRROR
Syntax
set switch mirror=
port
Parameter
mirror
Specifies the destination port for the port mirror. This is the port
where the traffic from the source ports will be copied. You can
specify only one port as the destination port. Specifying “0”
(zero) disables port mirroring.
Description
This command enables mirroring and specifies the destination port, or
disables mirroring. To select the source ports, refer to “SET SWITCH
PORT MIRROR” on page 195.
Examples
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command disables port mirroring:
set switch mirror=0
Advertising