Allied Telesis AT-S63 - Manual (Page 74)

Chapter 3: Basic Switch Commands
74 Section I: Basic Operations
SHOW IP INTERFACE
Syntax
show ip interface=eth0
Parameter
interface Specifies the switch’s interface number. This value is
always eth0.
Description
This command displays the IP address, subnet mask, and default gateway
address of the switch. Figure 6 is an example of the information displayed
by this command.
Figure 6. SHOW IP INTERFACE Command
To manually set the IP address and subnet mask, refer to “SET IP
INTERFACE” on page 58. To manually set the default gateway address,
refer to “SET IP ROUTE” on page 60. To enable the DHCP or BOOTP
client software, refer to “ENABLE BOOTP” on page 46, “ENABLE DHCP”
on page 47, “SET IP INTERFACE” on page 58, or “ENABLE IP
REMOTEASSIGN” on page 48.
Example
The following command displays the IP address, subnet mask, and default
gateway of the switch:
show ip interface=eth0
Equivalent Command
show ip route
This command displays just the default gateway address. For information,
refer to “SHOW IP ROUTE” on page 75.
IP Interface Information:
IP Address ........................... 149.44.44.44
Net Mask ............................. 255.255.255.0
Default Route ........................ 0.0.0.0