Set ip route – Allied Telesis AT-S63 User Manual
Page 60
Advertising
Chapter 3: Basic Switch Commands
60
Section I: Basic Operations
SET IP ROUTE
Syntax
set ip route ipaddress=
ipaddress
Parameter
ipaddress
Specifies the IP address of the default gateway for
the switch.
Description
This command specifies the IP address of the default gateway for the
switch. This IP address is required if you intend to remotely manage the
device from a remote management station that is separated from the unit
by a router. To display the current gateway address, refer to “SHOW IP
INTERFACE” on page 74.
Example
The following command sets the default gateway to 140.35.22.12:
set ip route ipaddress=140.35.22.12
Advertising