Allied Telesis AT-S63 - Manual (Page 235)

AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 235
The following command downloads a new version of the AT-S63 image file
to the switch’s file system instead of the application block. It does this by
replacing the APPBLOCK option with a filename, in this case
“ats63v1_2_0.img”. The image file is stored in the switch’s file system with
this name:
load method=xmodem destfile=ats63v1_2_0.img
Since the file is stored in the switch’s file system and not the application
block, the switch does not use it as its active image file. If, at some point in
the future, you want to make it the active image file, use “LOAD
METHOD=LOCAL” on page 226.