Show ip route – Allied Telesis AT-S63 User Manual
Page 75
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
75
SHOW IP ROUTE
Syntax
show ip route
Parameters
None.
Description
This command displays the switch’s default gateway address. To manually
set the default gateway address, refer to “SET IP ROUTE” on page 60.
Example
The following command displays the default gateway address of the
switch:
show ip route
Equivalent Command
show ip interface=eth0
This command displays the switch’s IP address and subnet mask in
addition to the default gateway address. For information, refer to “SHOW
IP INTERFACE” on page 74.
Advertising