Purge snmpv3 targetaddr – Allied Telesis AT-S63 User Manual
Page 432
Advertising
Chapter 25: SNMPv3 Commands
432
Section IV: SNMPv3
PURGE SNMPV3 TARGETADDR
Syntax
purge snmpv3 targetaddr
Parameters
None
Description
This command resets the SNMPv3 Target Address Table to its default
values by removing all the target address table entries. To remove a single
entry, use “DESTROY SNMPv3 TARGETADDR” on page 426.
Example
The following example removes all the entries from the SNMPv3 Target
Address Table:
purge snmpv3 targetaddr
Advertising