Allied Telesis AT-S63 - Manual (Page 130)

Chapter 7: Port Parameter Commands
130 Section I: Basic Operations
RESET SWITCH PORT
Syntax
reset switch port= port
Parameter
port Specifies the port to reset. You can specify the ports
individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current operating
parameter settings. To reset a port to the factory default settings, use
“PURGE SWITCH PORT” on page 129.
Example
The following command resets ports 5 to 8:
reset switch port=5-8
Equivalent Command
set switch port= port softreset
For information, see “SET SWITCH PORT” on page 131.