Allied Telesis AT-S63 - Manual (Page 480)

Chapter 27: Rapid Spanning Tree Protocols Commands
480 Section V: Spanning Tree Protocols
SET RSTP
Syntax
set rstp [default] [priority= priority ] [hellotime= hellotime ]
[forwarddelay= forwarddelay ] [maxage= maxage ]
[rstptype|forceversion=stpcompatible|
forcestpcompatible|normalrstp]
Parameters
default Returns all bridge and port RSTP settings to the default
values. This parameter cannot be used with any other
command parameter and only when RSTP is disabled.
(This parameter performs the same function as the
PURGE RSTP command.)
priority Specifies the priority number for the bridge. This
number is used in determining the root bridge for
RSTP. The bridge with the lowest priority number is
selected as the root bridge. If two or more bridges have
the same priority value, the bridge with the numerically
lowest MAC address becomes the root bridge. The
range is 0 to 61,440 in increments of 4,096. The range
is divided into sixteen increments, as shown in
Table 16. You specify the increment that represents the
desired bridge priority value. The default value is
32,768, which is increment 8.
Table 16. Bridge Priority Value Increments
Increment
Bridge
Priority
Increment
Bridge
Priority
0 0 8 32768
1 4096 9 36864
2 8192 10 40960
3 12288 11 45056
4 16384 12 49152
5 20480 13 53248
6 24576 14 57344
7 28672 15 61440