Allied Telesis AT-S63 - Manual (Page 203)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 203
SHOW IP ROUTE
Syntax
show ip route
Parameter
None
Description
This command displays the switch’s IP route table. An example is shown
in Figure 22.
Figure 22. SHOW IP ROUTE Command
The columns are defined here:
ˆ Destination - The IP address of a destination network, subnetwork, or
end node.
ˆ Mask - A filter used to designate the active part of the destination IP
address. A binary 1 in the mask indicates an active bit in the address
while a binary 0 indicates that the corresponding bit in the address is
not.
ˆ Next Hop - The IP address of the next intermediary device to reaching
the destination network, subnetwork, or end node.
ˆ Interface - The interface on the switch where the next hop is located.
The switch has two interfaces. The interface “loopback” is for internal
diagnostics only. The other interface is “eth0.”
Example
The following command displays the IP route table:
show ip route
Destination Mask Next Hop Interface
---------------------------------------------------------------
127.0.0.0
255.0.0.0 127.0.0.1 loopback
169.254.0.0 255.255.0.0 169.254.37.1 eth0
169.254.37.1 255.255.255.255 127.0.0.1 loopback