Allied Telesis AT-S63 - Manual (Page 160)

Chapter 9: MAC Address Table Commands
160 Section I: Basic Operations
RESET SWITCH FDB
Syntax
reset switch fdb [port= port ]
Parameter
port Specifies the port whose dynamic MAC addresses you
want to delete from the MAC address table. You can
specify more than one port at a time.
Description
This command deletes the dynamic MAC addresses learned by the
switch. You can delete all the dynamic addresses of addresses learned on
a specific port. After a port’s dynamic MAC addresses have been deleted,
the port begins to learn new addresses.
Example
The following command deletes all the dynamic MAC addresses in the
switch’s MAC address table:
reset switch fdb
The following command deletes all the dynamic MAC addresses learned
in port 5:
reset switch fdb port=5