Allied Telesis AT-S63 - Manual (Page 442)

Chapter 25: SNMPv3 Commands
442 Section IV: SNMPv3
SET SNMPV3 TARGETADDR
Syntax
set snmpv3 targetaddr= targetaddr params= params
ipaddress= ipaddress udpport= udpport timeout= timeout
retries= retries taglist= taglist
[storagetype=volatile|nonvolatile]
Parameters
targetaddr Specifies the name of the SNMP entity (NMS or
manager) that manages the SNMP activity on the
switch, up to 32 alphanumeric characters.
params Specifies the target parameters name, up to 32
alphanumeric characters. This is an optional
parameter.
ipaddress Specifies the IP address of the host. This is an
optional parameter.
udpport Specifies the UDP port in the range of 0 to 65535.
The default UDP port is 162. This is an optional
parameter.
timeout Specifies the timeout value in milliseconds. The
range is 0 to 2,147,483,647 milliseconds, and the
default is 1500 milliseconds. This is an optional
parameter.
retries Specifies the number of times the switch retries to
send an inform message. The default is 3. This is
an optional parameter.
taglist Specifies a tag or list of tags, up to 256
alphanumeric characters. Use a space to separate
entries. This is an optional parameter.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.