Allied Telesis AT-S63 - Manual (Page 580)

Chapter 34: 802.1x Port-based Network Access Control Commands
580 Section VII: Port Security
ENABLE PORTACCESS|PORTAUTH
Syntax
enable portaccess|portauth
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
None.
Description
This command activates 802.1x Port-based Network Access Control on
the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. Refer to
“SET AUTHENTICATION” on page 658.
Example
The following command activates 802.1x Port-based Network Access
Control on the switch:
enable portaccess