Allied Telesis AT-S63 - Manual (Page 433)

AT-S63 Management Software Command Line Interface User’s Guide
Section IV: SNMPv3 433
PURGE SNMPV3 VIEW
Syntax
purge snmpv3 view
Parameters
None
Description
This command resets the SNMPv3 View Table to its default values by
removing all the view table entries. To remove a single entry, use
“DESTROY SNMPV3 VIEW” on page 428.
Example
The following example removes all the entries from the SNMPv3 View
Table:
purge snmpv3 view