Allied Telesis AT-S63 - Manual (Page 570)

Chapter 33: MAC Address-based Port Security Commands
570 Section VII: Port Security
SET SWITCH PORT INTRUSIONACTION
Syntax
set switch port= port intrusionaction=discard|trap|disable
Parameters
port Specifies the port where you want to change the
intrusion action. You can specify more than one port
at a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22).
intrusionaction Specifies the action the port takes when it receives an
invalid frame. The options are:
discard The port discards invalid frames. This is
the default.
trap The port discards invalid frames and
sends an SNMP trap.
disable The port discards invalid frames, sends an
SNMP trap, and disables the port.
Description
This command defines what a port does when it receives an invalid frame.
and applies only to ports operating in the Limited security mode.
Example
The following command sets the intrusion action to trap on ports 12 and
21:
set switch port=12,21 intrusionaction=trap