Allied Telesis AT-S63 - Manual (Page 21)

AT-S63 Management Software Command Line Interface User’s Guide
21
AT-S63 Version
1.2.0
Table 2 lists the new features in version 1.2.0 of the AT-S63 management
software.
Table 2. New Features in AT-S63 Version 1.2.0
Change Chapter and Command
MAC Address Table
Added new parameters to the CLI
commands for deleting and displaying
specific types of MAC addresses in the
MAC address table. The new
parameters are:
ˆ STATIC, STATICUNICAST, and,
STATICMULTICAST for deleting
and displaying static unicast and
multicast MAC addresses.
ˆ DYNAMIC, DYNAMICUNICAST,
and, DYNAMICMULTICAST for
deleting and displaying dynamic
unicast and multicast MAC
addresses.
Chapter 9, “MAC Address Table Commands” on page
155
Modified commands:
“DELETE SWITCH FDB|FILTER” on page 158
“SHOW SWITCH FDB” on page 163
Quality of Service - Flow Groups and Traffic Classes
Added the following parameters to the
commands for creating and modifying
flow groups and traffic classes:
ˆ TOS parameter for replacing the
Type of Service (ToS) field of IPv4
packets.
ˆ MOVETOSTOPRIORITY
parameter for replacing the value in
the 802.1p priority field with the
value in the ToS priority field in
IPv4 packets.
ˆ MOVEPRIORITYTOTOS
parameter for replacing the value in
the ToS priority field with the
802.1p priority field in IPv4 packets.
Chapter 20, “Quality of Service (QoS) Commands” on
page 309
Modified commands:
“CREATE QOS FLOWGROUP” on page 313
“SET QOS FLOWGROUP” on page 335
“CREATE QOS TRAFFICCLASS” on page 323
“SET QOS TRAFFICCLASS” on page 342