Delete switch trunk – Allied Telesis AT-S63 User Manual
Page 172
Chapter 10: Static Port Trunking Commands
172
Section I: Basic Operations
DELETE SWITCH TRUNK
Syntax
delete switch trunk=
name
port=
port
Parameters
trunk
Specifies the name of the static port trunk to be
modified.
port
Specifies the port to be removed from the existing port
trunk. You can specify more than one port at a time.
Description
This command removes ports from a static port trunk. To completely
remove a port trunk from a switch, see “DESTROY SWITCH TRUNK” on
page 173.
Caution
Disconnect all data cables from the ports of the trunk on the switch
before using this command. Removing a port from a port trunk
without first disconnecting the cables may result in loops in your
network topology, which can produce broadcast storms and poor
network performance.
Note
You cannot remove ports from a trunk that has only two ports
because a static trunk must have a minimum of two ports.
Example
The following command removes port 9 from a port trunk called
Dev_trunk:
delete switch trunk=Dev_trunk port=9