Ping – Allied Telesis AT-S63 User Manual
Page 50
Advertising
Chapter 3: Basic Switch Commands
50
Section I: Basic Operations
PING
Syntax
ping
ipaddress
Parameter
ipaddress
Specifies the IP address of an end node you want the
switch to ping.
Description
This command instructs the switch to ping an end node. You can use this
command to determine whether a valid link exists between the switch and
another device.
Note
The switch must have an IP address and subnet mask for this
command.
Example
The following command pings an end node with the IP address of
149.245.22.22
ping 149.245.22.22
The results of the ping are displayed on the screen.
Advertising