Allied Telesis AT-S63 - Manual (Page 597)

AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Port Security 597
Figure 57. Authenticator Port Information
Figure 58 illustrates the information displayed for a supplicant port. For an
explanation of the parameters, refer to “SET PORTACCESS|PORTAUTH
PORT ROLE=SUPPLICANT” on page 590.
Figure 58. Supplicant Port Information
Examples
The following command displays the configuration and status for port 10,
which is an 802.1x authenticator port:
show portaccess=8021x port=10 authenticator
The following command displays the configuration and status for port 12
which is a MAC address-based authenticator port:
Port 1
PAE Type.................. Authenticator
Supplicant Mode........... Single
AuthControlPortControl.... Auto
quietPeriod............... 60
txPeriod.................. 30
suppTimeout............... 30
serverTimeout............. 30
maxReq.................... 2
reAuthPeriod.............. 3600
reAuthEnabled............. Enabled
vlanAssignment............ Enabled
secureVlan................ On
guestVlan................. None (VID=0)
adminControlDirection..... Both
piggyBack................. Disabled
Attached Supplicant(s)
MAC Address..................... -
Authenticator PAE State......... Connecting
Port Status..................... Unauthorized
Backend Authenticator State..... Initialize
Port 5
PAE Type.................. Supplicant
heldPeriod...................... 60
authPeriod...................... 30
startPeriod..................... 30
maxStart........................ 3
Supplicant PAE State............ Connecting