Allied Telesis AT-S63 - Manual (Page 129)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 129
PURGE SWITCH PORT
Syntax
purge switch port= port
Parameters
port Specifies the port to reset. You can specify more than
one port at a time. You can specify the ports individually
(for example, 5,7,22), as a range (for example, 18-23),
or both (for example, 1,5,14-22).
Description
This command resets all the port’s settings back to the factory default
values. To reset a port and retain its settings, use “RESET SWITCH
PORT” on page 130.
Example
The following example resets the settings for port 10 to the factory default
values:
purge switch port=10