Disable garp – Allied Telesis AT-S63 User Manual
Page 534
Chapter 30: GARP VLAN Registration Protocol Commands
534
Section VI: Virtual LANs
DISABLE GARP
Syntax
disable garp=gvrp [gip]
Parameters
garp
Specifies the GARP application you want to disable.
The only GARP application supported by AT-S63
management software is GVRP.
gip
Disables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command disables GVRP on the switch. After disabled, the switch
will not learn any new dynamic GVRP VLANs or dynamic GVRP ports.
You can also use this command to disable GIP.
Note
Do not disable GIP if the switch is running GVRP. GIP is required for
proper GVRP operation.
Examples
The following command disables GVRP on the switch:
disable garp=gvrp
The following command disables GIP only:
disable garp=gvrp gip