Set switch infiltering – Allied Telesis AT-S63 User Manual
Page 524
Chapter 29: Port-based, Tagged, and Multiple Mode VLAN Commands
524
Section VI: Virtual LANs
SET SWITCH INFILTERING
Syntax
set switch infiltering=yes|no|on|off|true|false
Parameters
infiltering
Specifies the operating status of ingress filtering.
The options are:
yes, on, true
Activates ingress filtering. The
options are equivalent. This is the
default.
no, off, false Deactivates ingress filtering. The
options are equivalent.
Description
This command controls the status of ingress filtering. When ingress
filtering is activated, which is the default, tagged frames are filtered when
they are received on a port. When ingress filtering is deactivated, tagged
frames are filtered before they are transmitted out a port. To view the
current setting, use the “SHOW SWITCH” on page 76. For further
information on ingress filtering, refer to the AT-S63 Management Software
Menus Interface User’s Guide.
Example
The following command deactivates ingress filtering:
set switch infiltering=off