Allied Telesis AT-S63 - Manual (Page 72)

Chapter 3: Basic Switch Commands
72 Section I: Basic Operations
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. If neither is activated on the switch, the command
displays the message in Figure 3.
Figure 3. SHOW DHCPBOOTP Command
If DHCP is activated, the command displays the prompt in Figure 4.
Figure 4. SHOW DHCPBOOTP Command - DHCP Activated
If BOOTP is activated on the switch, the command displays the prompt in
Figure 5.
Figure 5. SHOW DHCPBOOTP Command - BOOTP Activated
DHCP and BOOTP cannot both be active on a switch at the same time.
The default setting for the DHCP and BOOTP client software is disabled.
To enable the DHCP or BOOTP client software, refer to “ENABLE
BOOTP” on page 46, “ENABLE DHCP” on page 47, “SET IP
INTERFACE” on page 58, or “ENABLE IP REMOTEASSIGN” on page 48.
To disable the client software, refer to “DISABLE DHCPBOOTP” on
page 43 or “DISABLE IP REMOTEASSIGN” on page 44.
DHCP/BOOTP Information:
Status ............................... DISABLE
DHCP/BOOTP Information:
Status ............................... DHCP
DHCP/BOOTP Information:
Status ............................... BOOTP