Allied Telesis AT-S63 - Manual (Page 97)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 97
SET TIME
Syntax
set time= hh:mm:ss
Parameter
time Specifies the hour, minute, and second for the switch’s
time in 24-hour format.
Description
This command sets the time on the switch. You can use this command to
set the switch’s time if you are not using an SNTP server. The AT-9400
Series switch has an onboard battery that maintains the time even when
the unit is powered off or reset.
Example
The following command sets the switch’s time to 4:34 pm and 52 seconds:
set time=16:34:52