Allied Telesis AT-S63 - Manual (Page 509)

AT-S63 Management Software Command Line Interface User’s Guide
Section V: Spanning Tree Protocols 509
SHOW MSTP
Syntax
show mstp [portconfig= ports ] [portstate= ports ]
[stpid= msti_id ] [mstistate] [cist] [mstivlanassoc]
Parameters
portconfig Displays the MSTP settings of a port. You can specify
more than one port at a time. For a list of the MSTP
information displayed by this parameter, refer to
Description below.
portstate Displays the MSTP state of a port. You can specify
more than one port at a time. For a list of the MSTP
information displayed by this parameter, refer to
Description below.
stpid Specifies an MSTI ID. This parameter is used with the
PORTCONFIG and PORTSTATE parameters to view
MSTP settings for a port whose VLANs are members of
different MSTIs. You can specify more than one MSTI
ID.
mstistate Displays a list of the MSTIs on the switch and their
associated VLANs. The list does not include the CIST.
cist Displays the CIST priority and the VLANs associated
with CIST.
mstivlanassoc Displays a list of the MSTIs on the switch, including the
CIST, and their associated VLANs.
Note
You can specify only one parameter at a time in this command. The
only exception is the STPID parameter, which can be used together
with the PORTCONFIG and PORTSTATE parameters.
Description
This command displays MSTP parameters. For definitions of the MSTP
terms used below, refer to Chapter 24, “Multiple Spanning Tree Protocol”
in the AT-S63 Management Software Menus Interface User’s Guide.