Table 10. event log severity levels – Allied Telesis AT-S63 User Manual
Page 271
AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations
271
An example of the event log is shown in Figure 28. The example uses
the full display mode.
Figure 28. Event Log Example
The columns in the log are described below:
S (Severity) - The event’s severity. Refer to Table 10 on page 271.
Date/Time - The date and time the event occurred.
Event - The module within the AT-S63 software that generated the
event followed by a brief description of the event. For a list of the
AT-S63 modules, see Table 9 on page 269.
Event ID - A unique number that identifies the event. (Displayed only in
the full display mode.)
Filename and Line Number - The subpart of the AT-S63 module and
the line number that generated the event. (Displayed only in the full
display mode.)
Table 10. Event Log Severity Levels
Value
Severity Level
Description
E
Error
Switch operation is severely impaired.
W
Warning
An issue may require manager attention.
I
Informational
Useful information that can be ignored
during normal operation.
D
Debug
Messages intended for technical support
and software development.
S Date
Time
EventID
Source File:Line Number
Event
------------------------------------------------------------------
I 2/01/04
09:11:02
073001
garpmain.c:259
garp: GARP initialized
I 2/01/04
09:55:15
083001
portconfig.c:961
pcfg: PortConfig initialized
I 2/01/04
10:22:11
063001
vlanapp.c:444
vlan: VLAN initialization succeeded
I 2/01/04
12:24:12
093001
mirrorapp.c:158
pmirr: Mirror initialization succeeded
I 2/01/04
12:47:08
043016
macapp.c:1431
mac: Delete Dynamic MAC by Port[2] succeeded