Allied Telesis AT-S63 - Manual (Page 188)

Chapter 11: LACP Port Trunking Commands
188 Section I: Basic Operations
SET LACP STATE
Syntax
set lacp state=enable|disable
Parameters
state Specifies the state of LACP on the switch. The options are:
enable Enables LACP.
disable Disables LACP. This is the default.
Description
This command enables or disables LACP on the switch.
Caution
Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop might occur, resulting in a broadcast
storm and poor network performance.
Example
The following command activates LACP on the system:
set lacp state=enable
Equivalent Commands
disable lacp
For information, see “DISABLE LACP” on page 183.
enable lacp
For information, see “ENABLE LACP” on page 184.