Allied Telesis AT-S63 - Manual (Page 278)

Chapter 17: Classifier Commands
278 Section II: Advanced Operations
CREATE CLASSIFIER
Syntax
create classifier= idnumber [description=” string ”]
[macdaddr= macaddress |any] [macsaddr= macaddress |any]
[ethformat=ethii-untagged|ethii-tagged|802.2-
untagged|802.2-tagged|any]
[priority=
integer |any] [vlan= name |1..4094|any]
[protocol=ip|arp|rarp| number |any] [iptos= integer |any]
[ipdscp= integer ] [ipprotocol= protocol | number |any]
[ipdaddr= ipaddress / mask |any]
[ipsaddr= ipaddress / mask |any] [tcpsport= integer |any]
[tcpdport= integer |any] [udpsport= integer |any]
[udpdport= integer |any]
[tcpflags=[urg|ack|psh|rst|syn|fin|any]
Parameters
classifier Specifies the ID number of the classifier. The number can
be from 1 to 9999. Each classifier must be assigned a
unique ID number. This parameter is required.
description Specifies a description of the classifier. A description can
be up to fifteen alphanumeric characters. Spaces are
allowed. If it contains spaces, it must be enclosed in double
quotes. Otherwise, the quotes are optional.
macdaddr Specifies a destination MAC address. The address can be
entered in either of the following formats:
xx:xx:xx:xx:xx:xx or xxxxxxxxxxxx
macsaddr Specifies a source MAC address. The address can be
entered in either of the following formats:
xx:xx:xx:xx:xx:xx or xxxxxxxxxxxx
ethformat Specifies the type of Ethernet frame that needs to be
classified. The options are:
ethII-untagged
ethII-tagged
802.2-untagged
802.2-tagged
priority Specifies the user priority level in a tagged Ethernet frame.
The value can be 0 to 7.