Allied Telesis AT-S63 - Manual (Page 431)

AT-S63 Management Software Command Line Interface User’s Guide
Section IV: SNMPv3 431
PURGE SNMPV3 NOTIFY
Syntax
purge snmpv3 notify
Parameters
None
Description
This command resets the SNMPv3 Notify Table to its default value by
removing all the notify table entries. To remove a single entry, use
“DESTROY SNMPv3 NOTIFY” on page 425.
Example
The following example removes all the entries from the SNMPv3 Notify
Table:
purge snmpv3 notify