Allied Telesis AT-S63 - Manual (Page 294)

Chapter 18: Access Control List Commands
294 Section II: Advanced Operations
SET ACL
Syntax
set acl= value [description= string ]
[action=deny|permit] [classifierlist= value ]
[portlist= ports |none]
Parameters
acl Specifies the ID number of the ACL you want to modify.
The number can be from 0 to 255. You can modify only
one ACL at a time.
description Specifies a new description for the ACL. A description
can be up to 15 alphanumeric characters. Spaces are
allowed. If the description contains a space, it must be
enclosed in double quotes. Otherwise, the quotes are
optional.
action Specifies the new action to be taken by the port when
an ingress packet matches a classifier attached to the
ACL. Options are:
permit The port accepts the packet.
deny The port discards the packet, provided that
the packet does not match the classifier of a
permit ACL assigned to the same port.
classifierlist Specifies the new ID numbers of the classifiers to be
assigned to the ACL. Any classifier IDs already
assigned to the ACL are overwritten. When entering
multiple ID numbers, separate the numbers with a
comma (e.g., 4,6,7). The classifiers must already exist
on the switch. The order in which you specify the
classifiers is not important. An ACL must be assigned at
least one classifier.
portlist Specifies the new ports to be assigned this ACL. Any
ports to which the ACL is assigned are overwritten. You
can assign an ACL to more than one port. When
entering multiple ports, the ports can be listed
individually (e.g., 2,5,7), as a range (e.g., 8-12) or both
(e.g., 1-4,6,8). Entering NONE removes all ports to
which the ACL is already assigned without assigning
any new ports. An ACL without assigned ports exists,
but remains nonfunctional until assigned to a port.