Avaya P580 - Manual (Page 222)

5-42 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter 5
Enabling NEDR
You can enable NEDR only on Gigabit Ethernet ports and only by
using CLI commands.
To enable NEDR:
1. Enter Global Configuration mode.
The CLI displays the <configure># prompt.
* Note: For information on how to enter this mode, see
“Accessing/Exiting the Command Modes” in
Chapter 1, “Overview,” of Command Reference
Guide for the Avaya P550R, P580, P880, and P882
Multiservice Switches, Version 5.3.
2. Enter the following command:
<configure># set port network-error-detection {<mod-
port-range> | <all>} [action {notify | disable-port | off}]
[rising-threshold <rising-threshold-value>] [falling-
threshold <falling-threshold-value>] [interval
<interval-seconds>]
Table 6-2 explains the keywords, arguments, and options for the set
port network-error-detection command:.
Table 6-2. set port network-error-detection Keywords,
Arguments, and Options
Keywords,
Arguments and
Options Explanation
<mod/port-range> The slot number of the module, and, either
port number, or range of port numbers.
Enter the port ranges in the format
Px - Py .
For example:
• To specify port 1 on the module in slot
3, enter 3/1.
• To specify ports 1 through 5 on the
module in slot 3, enter 3/1-5.
all Disables NEDR on all ports on all modules in
the switch. all can be used only with off.
1 of 2