Creating ospf areas, Creating ospf areas -5, Using the cli – Avaya P580 User Manual
Page 423: Using the web agent
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
11-5
Configuring the OSPF Routing Protocol
Using the CLI
To globally configure OSPF using the CLI, enter the following
command in Configure mode:
> (configure)# router ospf
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
Creating OSPF Areas
You can create OSPF areas using either the Web Agent or the CLI.
Using the Web
Agent
To create OSPF areas using the Web Agent:
1. Select Areas from the Routing > IP > OSPF group on the
Web Agent window. The OSPF Areas dialog box opens
(Figure 6-79).
* Note: The Area ID 0.0.0.0 is a backbone area and
always exists in an OSPF configuration.
Figure 6-79. OSPF Areas Dialog Box
2. Click CREATE. The Add OSPF Area dialog box opens
(Figure 11-3).