Avaya P580 - Manual (Page 426)

11-8 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter
Using the CLI
To delete an OSPF area using the CLI, enter the following command
in Enable/Configure mode:
* Note: Before deleting an OSPF area, assign any interfaces that
are associated with the area to a different area or delete
the interfaces.
<configure router: ospf># no area <area-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
Modifying OSPF Areas
You can modify the parameters of an OSPF area using either the
Web Agent or the CLI.
Using the Web
To modify an OSPF area using the Web Agent:
1. Select Areas from the Routing > IP > OSPF group on the
Web Agent window. The OSPF Areas dialog box opens
(Figure 6-79).
2. Select an OSPF Area to be modified from the Select field.
3. Refer to Table 6-54 and modify the OSPF Area dialog box
parameters.
4. Click Apply to save your changes, or Cancel to ignore your
changes.
Using the CLI
To modify an OSPF area using the CLI, enter the following
command in Enable/Configure mode:
>(configure router ospf)# area <area-id> <option>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.