Configuring ipx rip protocol, Overview, Chapter 13 — configuring ipx rip protocol -1 – Avaya P580 User Manual
Page 483: Overview -1, Protocol (rip) interfaces -1
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
13-1
13
Configuring IPX RIP
Protocol
Overview
The information and procedures provided in this chapter pertain to
layer 3 module configuration only. This chapter provides the
following procedures:
■
Configuring Internetwork Packet Exchange (IPX) Routing
Interface Protocol (RIP) Interfaces
■
Creating and Modifying IPX RIP Filters
Configuring Internetwork Packet Exchange (IPX) Routing
Interface Protocol (RIP) Interfaces
You can configure IPX RIP interfaces using either the Web Agent or
the CLI.
Configuring IPX
RIP Interfaces
Using the Web
Agent
To configure IPX RIP interfaces using the Web Agent:
1. Select Interfaces from the Routing > IPX > RIP group on
the Web Agent window. The IPX RIP Interfaces dialog box
opens (Figure 6-108). If no IPX interfaces are presently
configured then the “No Interfaces are currently configured”
message is displayed.
Figure 6-108. IPX RIP Interfaces Dialog Box