Avaya P580 - Manual (Page 78)

2-20 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter 2
3. Select the check box next to the manuf or diag account that
you want to disable.
4. Select Modify.
The Modify User Account Web page opens.
5. In the Status field, select Disable.
CLI Command
To disable the user accounts using the CLI, enter the following CLI
command:
Avaya>username {names} access-type {enable | disable}
Where name is the user account name.
Setting Up SNMP Communities
SNMP is identified on a switch through SNMP communities. SNMP
communities are configured to manage the switch. You set up
SNMP communities using either the Web Agent or the CLI.
* Note: SNMP Version 2c is supported.
All three switches support a maximum of ten SNMP
community strings.
Setting Up
SNMP
Communities
Using the Web
Agent
To set the SNMP communities parameters using the Web Agent:
1. Select SNMP Administration from the System >
Administration folder on the Web Agent. The SNMP
Community Management window opens
(Figure 2-13).
Figure 2-13. SNMP Community Management Window
2. Select CREATE. The Create SNMP Community dialog
box opens (Figure 2-14).