Rice Lake PR5220 Ethernet Transmitter - Manual (Page 108)

Commissioning PR 5220 Instrument Manual
EN-108 Sartorius
4.9.2 Configuring Digital Inputs
An action both for signal change from 0 to 1 (on) and from 1 to 0 (off) can be determined for each of the three
inputs. Digital inputs can be linked with conditions that must be met before an action can be started.
Press and select [Digital I/O parameter] to open the configuration menu.
Setup/ Digital I/O parameter
Output 1 marker bit 1 X64=1
Output 2 marker bit 2 X65=1
Output 3 marker bit 3 X66=1
Input 1 on set tare X113=1
Condition no condition -----
Input 1 off -no action-
Input 2 on -no action-
Input 2 off -no action-
Input 3 on -no action-
Input 3 off -no action-
BCD out Gross
1. Determining an action
Determine the action for the rising edge of input 1 under [Input 1 on] from the following list (here: When the
input signal changes from 0 to 1, a tare command is generated).
Accordingly, an action for the falling edge can be determined.
Selection list for actions of the inputs [Input 1/2/3 on/off]
Function SPM bit Description
-no action- ----- No function
set marker 1 X64=1 Set marker 1
set marker 2 X65=1 Set marker 2
set marker 3 X66=1 Set marker 3
select net X72=1 Select net
set zero X112=1 Set zero
set tare X113=1 Set tare
reset tare X114=1 Reset tare
set test X115=1 Activate the analog test
reset test X116=1 Finish the analog test
reset PWF X117=1 Reset power fail
set fixtare X118=1 Set fixtare (use the value in address D31 as a tare value)
get fixtare X119=1 Save gross value as fixtare in address D31
set print X120=1 Activate a print order
clr marker 1 X64=0 Clear marker 1
clr marker 2 X65=0 Clear marker 2
clr marker 3 X66=0 Clear marker 3
select gross X72=0 Save the gross weight in address D11