Rice Lake PR5220 Ethernet Transmitter - Manual (Page 145)

PR 5220 Instrument Manual Global SPM Variables
Sartorius EN-145
8 Global SPM Variables
Definined ranges are assigned to firmware functions.
Weights are DINT formats in 'kg' or 'lb', depending on scale configuration.
For communication via OPC, the following variables are available:
Format Address for
read [R]/
write [W]
Funktion Address
BOOL R Digital input 1 X0
BOOL R Digital input 2 X1
BOOL R Digital input 3 X2
BOOL R Digital output 1 X8
BOOL R Digital output 2 X9
BOOL R Digital output 3 X10
BOOL R Output limit 1 X16
BOOL R Output limit 2 X17
BOOL R Output limit 3 X18
BOOL R ADC error X32
BOOL R Above Max (FSD) X33
BOOL R Overload, above (Max + plus the range that is still permissible) X34
BOOL R Below zero X35
BOOL R Zero ±¼d X36
BOOL R Within the zero setting range X37
BOOL R The weight is stable X38
BOOL R Below zero or above Max X39
BOOL R Load cell measuring signal negative (error 7) X40
BOOL R Load cell measuring signal >36 mV (error 3) X41
BOOL R Internal arithmetic error; CAL data are perhaps faulty (error 1) X42
BOOL R No or too low sense voltage (error 6) X43
BOOL R No Communication with xBPI scale (error 9) X44
BOOL R Command error X48
BOOL R Command active X49
BOOL R Power fail signal X50
BOOL R Test mode active X56
BOOL R Calibration active X57
BOOL R Instrument is tared X58
BOOL R/W Read/write marker bit 1 X64
BOOL R/W Read/write marker bit 2 X65
BOOL R/W Read/write marker bit 3 X66
BOOL W Switch D11 to net weight X72